Revisiting: Drawing up with one needle and injecting with another

Revisiting: Drawing up with one needle and injecting with another Writing it up because I had to work it out twice and would rather nobody else did.

Practical question with the units stated, because I have seen how quickly these go wrong without them.

I have a 2 mg vial of tirzepatide and I am working to a 1.0 mg step. My syringes are U-100 insulin syringes, 1.0 mL barrel.

I can do the arithmetic and I have done it twice, getting the same answer both times, but I would like someone to check the reasoning rather than the number — specifically whether I have thought about the residual volume correctly, and whether the graduation I am landing on is one a person can actually read.

Worth separating two things that the opening post runs together.

Angle of injection: 90 degrees into pinched tissue ensures subcutaneous placement. It is not always necessary and shallower angles can work, but 90 degrees into a small pinch is the safest technique to learn first.

Worth separating two things that post #8 runs together.

Two things before anyone answers the substance.

First, the context in the first post is clear and specific. Second, the question is framed so that an answer can actually address it. Both are the norm here and both matter more than they sound.

Bleeding at the injection site: normal and usually minimal. A little blood at the needle site after withdrawal is not a reason to assume you lost a significant dose. The needle passed through tissue and there is a small amount of bleeding in the tract.

This follows post #25 rather than contradicting it.

Air bubbles in a subcutaneous injection: the honest risk assessment is low. Tiny air bubbles in subcutaneous tissue do not behave like an air embolism in a blood vessel. A few air bubbles are not a reason to restart the entire injection.

Injecting into an area that has become firm: lipohypertrophy — thickened fatty tissue from repeated injection in one area — changes local tissue absorption. Avoid injecting into areas that are noticeably firm or lumpy and allow those areas to recover for at least a few months.

Cold solution and stinging: warming the vial in your hands for a minute before injection reduces the stinging sensation substantially. This is the simplest thing to try if injections are uncomfortable.

post #50 answers the question as asked. The question underneath it is different.

Pinch or no pinch: the decision depends on needle length and on your own anatomy. A longer needle (8 mm and up) reaches subcutaneous tissue easily without a pinch. A shorter needle (4-6 mm) is safer with a gentle pinch. The pinch size matters less than people think; the injection angle matters more.

post #61 is right about the mechanism and I think understates the practical bit.

Injection discomfort: comes from needle gauge (finer = less discomfort), volume (smaller = less discomfort), temperature (room temperature or warmed is less uncomfortable than cold), and technique (smooth, purposeful injection is less uncomfortable than hesitant). All four are under your control.