A checklist for reading a certificate in under two minutes

Thank you for the correction. I have edited my earlier post with a note rather than silently, so the thread still makes sense to read. The error was mine and it was the kind that comes from remembering a figure instead of looking it up.

Endotoxin testing is separate: a certificate of purity says nothing about endotoxin. A chemically pure preparation can carry a clinically significant endotoxin load. If endotoxin matters, it needs to be tested and reported.

post #16 is right about the mechanism and I think understates the practical bit.

Amino acid analysis gives content: it hydrolyses the peptide and quantifies the residues. It measures the peptide content independent of chromatographic purity. Very few supplier certificates report it.

Worth separating two things that post #14 runs together.

Counter-ion form is crucial: peptides are isolated as salts, most often trifluoroacetate from reversed-phase purification or acetate after salt exchange. The counter-ion is part of the mass in the vial and is not part of the peptide. Two vials of the same purity, one as TFA and one as acetate, contain different amounts of peptide per milligram.

A certificate of analysis is a statement by its issuer that a defined test was performed on a defined lot and produced a defined result. That is all it is, and it is not nothing. What makes it usable: lot identifier matching the container, test date, method identification specific enough to reproduce, the actual result as a number, and the acceptance criterion stated separately from the result.

Coming back to post #18, because the follow-up matters more than the original answer.

When method identifiers are missing: "reversed-phase HPLC" is less specific than "reversed-phase HPLC at 214 nm on a C18 column with a 10 to 40% acetonitrile gradient over 20 minutes". The second lets someone reproduce the analysis. The first does not.

Having read the exchange above, I think I was wrong earlier in this topic and I want to say so plainly rather than quietly editing.

The correction was fair and I had been repeating something I had not checked carefully enough.

Purity and content are different measurements: purity tells you what proportion of the detected material is the intended species. Content tells you how much of the intended species is present in the container. A lyophilised vial can be 99% pure and contain considerably less than the label claims because the remainder is water, counter-ion and excipient.

On post #19 — agreed on the reasoning, with one qualification.

When a document puts the specification in the result column, it has told you the release criterion, not the measurement. Those are different claims and the second is weaker.

Water content (residual moisture) matters: lyophilised peptide is not dry. A few percent water is normal. The difference between a TFA salt and an acetate salt can be several percent. Content calculations need the water content to be accurate.

What fields matter on a certificate: lot number matching the vial, test date, the analytical method stated specifically, the measured result as a number, and the acceptance limit stated separately. A certificate missing any of these is weaker.

This follows post #23 rather than contradicting it.

Thank you for the correction. I have edited my earlier post with a note rather than silently, so the thread still makes sense to read. The error was mine and it was the kind that comes from remembering a figure instead of looking it up.

Sterility testing is separate: chromatographic purity, mass spectrometry, and endotoxin testing all say nothing about whether a solution is sterile. If sterility matters, it needs to be tested and reported.

Reading old certificates: if a certificate is dated years ago, the lot it describes might be old. That is not automatically a problem but it is worth noting. Fresh testing on the current lot is stronger than old testing on an older lot.

Coming back to post #27, because the follow-up matters more than the original answer.

Reading old certificates: if a certificate is dated years ago, the lot it describes might be old. That is not automatically a problem but it is worth noting. Fresh testing on the current lot is stronger than old testing on an older lot.

When method identifiers are missing: "reversed-phase HPLC" is less specific than "reversed-phase HPLC at 214 nm on a C18 column with a 10 to 40% acetonitrile gradient over 20 minutes". The second lets someone reproduce the analysis. The first does not.