Reading U-100 graduations, with a conversion table — one year on

Reading U-100 graduations, with a conversion table — one year on Writing it up because I had to work it out twice and would rather nobody else did.

Practical question with the units stated, because I have seen how quickly these go wrong without them.

I have a 2 mg vial of retatrutide and I am working to a 2.5 mg step. My syringes are U-100 insulin syringes, 1.0 mL barrel.

I can do the arithmetic and I have done it twice, getting the same answer both times, but I would like someone to check the reasoning rather than the number — specifically whether I have thought about the residual volume correctly, and whether the graduation I am landing on is one a person can actually read.

Aspirating before injection: for subcutaneous injection, aspirating (pulling back on the plunger to check for blood) is not necessary and is sometimes discouraged because it is associated with more discomfort. Subcutaneous injection without aspiration is standard practice.

I read the opening post twice before replying, because I had assumed the opposite.

Syringe barrel size: common sizes are 0.3 mL, 0.5 mL, and 1.0 mL. Smaller barrels are more legible for small doses. Larger barrels hold larger volumes. Choose based on your dose.

On the opening post — agreed on the reasoning, with one qualification.

Needle length: typical lengths for subcutaneous injection are 4-6 mm (short), 8 mm (standard), or 10-12 mm (longer). Longer needles are needed for deeper tissue or if you have abdominal adiposity.

Needle gauge: smaller numbers (30G) are finer and less painful. Larger numbers (25G) are courser. For subcutaneous injection, 27-30G is typical. Finer needles take longer to draw up but hurt less.