Reading a syringe in poor light, and how to avoid needing to — what changed since

Posting this under the heading it deserves: Reading a syringe in poor light, and how to avoid needing to — what changed since Everything below is what sits behind that.

I have read the maintained page on this and I still have a gap, so I am asking rather than guessing.

Context: semaglutide, 21 weeks in, currently at a dose I reached by the standard four-week steps. Everything below is my own record rather than anything a clinician told me.

The specific question is the one in the title. What I have already checked: the labelling summary on the relevant documentation page, the two most-linked topics in this subcategory, and my own notes from the last 10 weeks. What I could not find is whether the answer changes at higher doses or whether it is the same arithmetic throughout.

If the answer is "it depends", I would rather know what it depends on than be given a number.

Practical note that does not fit anywhere else. Whatever you conclude from this topic, write down what you did and when. The single most useful thing in your own records is not any individual result; it is that they are dated and consecutive.

Picking up post #2: that is the part I would want checked first.

Syringe barrel size: common sizes are 0.3 mL, 0.5 mL, and 1.0 mL. Smaller barrels are more legible for small doses. Larger barrels hold larger volumes. Choose based on your dose.

Coming back to post #3, because the follow-up matters more than the original answer.

Dead volume: residual liquid in the hub and needle after withdrawal. Typical residual is 0.01 to 0.02 mL for an insulin syringe with a fixed needle. Accounting for it matters if precision matters.

Thank you for the correction. I have edited my earlier post with a note rather than silently, so the thread still makes sense to read. The error was mine and it was the kind that comes from remembering a figure instead of looking it up.

Insulin syringe graduations: U-100 syringes are marked in units where 100 units = 1 mL. Always confirm your syringe is U-100. Confusion between insulin units and milligrams is the most common syringe error.

Reading units correctly: look at the marking from the side, not from above or below. The bottom of the plunger tip is the reading. Parallax error (wrong angle) is a source of dosing error.

I read post #6 twice before replying, because I had assumed the opposite.

Aspirating before injection: for subcutaneous injection, aspirating (pulling back on the plunger to check for blood) is not necessary and is sometimes discouraged because it is associated with more discomfort. Subcutaneous injection without aspiration is standard practice.