Revisiting: Filter needles: when they help and what they cost you

Revisiting: Filter needles: when they help and what they cost you — setting out what I have, and where I think it stops being reliable.

A question about technique rather than about dose.

I have been doing the same thing for 3 months and it works, and then I read one of the documentation pages here and realised I may have been reasoning from a misunderstanding the whole time. Nothing has gone wrong; I would just like to understand why it has not.

What I do, exactly, is described below. Please tell me which parts are load-bearing and which are superstition.

Aspirating before injection: for subcutaneous injection, aspirating (pulling back on the plunger to check for blood) is not necessary and is sometimes discouraged because it is associated with more discomfort. Subcutaneous injection without aspiration is standard practice.

Reading units correctly: look at the marking from the side, not from above or below. The bottom of the plunger tip is the reading. Parallax error (wrong angle) is a source of dosing error.

the opening post answers the question as asked. The question underneath it is different.

Thank you for the correction. I have edited my earlier post with a note rather than silently, so the thread still makes sense to read. The error was mine and it was the kind that comes from remembering a figure instead of looking it up.

I read post #3 twice before replying, because I had assumed the opposite.

Needle length: typical lengths for subcutaneous injection are 4-6 mm (short), 8 mm (standard), or 10-12 mm (longer). Longer needles are needed for deeper tissue or if you have abdominal adiposity.

Needle gauge: smaller numbers (30G) are finer and less painful. Larger numbers (25G) are courser. For subcutaneous injection, 27-30G is typical. Finer needles take longer to draw up but hurt less.

Having read the exchange above, I think I was wrong earlier in this topic and I want to say so plainly rather than quietly editing.

The correction was fair and I had been repeating something I had not checked carefully enough.

Syringe barrel size: common sizes are 0.3 mL, 0.5 mL, and 1.0 mL. Smaller barrels are more legible for small doses. Larger barrels hold larger volumes. Choose based on your dose.

Practical note that does not fit anywhere else. Whatever you conclude from this topic, write down what you did and when. The single most useful thing in your own records is not any individual result; it is that they are dated and consecutive.

Picking up post #7: that is the part I would want checked first.

Insulin syringe graduations: U-100 syringes are marked in units where 100 units = 1 mL. Always confirm your syringe is U-100. Confusion between insulin units and milligrams is the most common syringe error.

Fixed versus detachable needles: insulin syringes usually have fixed needles (no dead volume loss to the hub). Luer-lock syringes use detachable needles (more dead volume). Fixed needles are preferred for small doses.

Coming back to post #10, because the follow-up matters more than the original answer.

Dead volume: residual liquid in the hub and needle after withdrawal. Typical residual is 0.01 to 0.02 mL for an insulin syringe with a fixed needle. Accounting for it matters if precision matters.

post #12 answers the question as asked. The question underneath it is different.

Thank you for the correction. I have edited my earlier post with a note rather than silently, so the thread still makes sense to read. The error was mine and it was the kind that comes from remembering a figure instead of looking it up.

Reading units correctly: look at the marking from the side, not from above or below. The bottom of the plunger tip is the reading. Parallax error (wrong angle) is a source of dosing error.