Injection volume, overload, and peak distortion — one year on

Injection volume, overload, and peak distortion — one year on Writing it up because I had to work it out twice and would rather nobody else did.

A documentation question rather than an analytical one.

I have a certificate in front of me that reports a purity figure, names a technique, gives a wavelength, and stops. No gradient, no column, no injection volume, no chromatogram.

What can I legitimately conclude from that document? My instinct is "almost nothing, but not literally nothing", and I would like to know where the people who read these professionally draw the line.

System suitability testing: injections run before and during the sample run to establish whether the instrument, column and method were performing when the sample was analysed. If suitability did not pass, the sample results from that run are uninterpretable.

On the opening post — agreed on the reasoning, with one qualification.

Before anything else: what was the gradient, and at what wavelength? Area percent at different wavelengths is not the same number even on the same sample because different species absorb differently at different wavelengths. With the method stated, I can tell you something useful. Without it, all I can say is that there is one large peak.

Reversed-phase separates on hydrophobicity. A peptide is retained on a non-polar stationary phase and eluted by increasing organic solvent. For peptides the mobile phase almost always contains an ion-pairing acid, typically 0.1% TFA, which suppresses secondary interactions and sharpens peaks.

Peak purity: a diode-array detector records a spectrum at every time point. If a peak contains two co-eluting species with different spectra, the spectrum changes across the peak. A passing peak-purity result says the spectrum is constant; it is weak evidence of homogeneity if the impurities have similar spectra.